LabVIEW examples: Advanced

Basic NXT flags
Basic NXT flags

These examples demonstrate some advanced features in LabVIEW.

Using a Sub VI

  • This example shows a possible implementation of a sub VI.ย  Sub VI’s are essentially consolidations of other code into one icon.

Multiple NXTs

  • This example demonstrates how to use multiple NXTs. After specifying which NXTs to use, the program uses motors on both NXTs.

Multiple NXT Flags

  • This example demonstrates the use of multiple NXT flags. A robot is programmed to constantly check if the light sensor is on a dark surface, the touch sensor is pressed, and if the ultrasonic sensor is more than 10 cm away from an object.ย  If any of these conditions are met, a corresponding flag is set to true and the parallel while loop reacts accordingly.

Basic NXT Flag

  • This example shows a very basic use of the NXT flag function.ย  A flag is created and set to true only when the touch sensor is pressed.ย  The flag is then used as a stop condition for a while loop.


The following two tabs change content below.


The Tufts Center for Engineering Education and Outreach (CEEO) in Boston, Massachusetts, is dedicated to improving engineering education in the classroom, from Kindergarten to college. The Center houses faculty, staff, and graduate students from engineering disciplines and the education department.

Latest posts by CEEO (see all)